Visbella Dent & Ding Repair Kit

Visbella DIY Dent & Ding repair kit is useful to remove small dings and dents from car doors, roofs etc. by yourself and without damaging the car paint. It can be used after small collisions or hailing, all over the car body surface, except borders and angles.

Kit Contains

• 1 x Glue Gun
• 1 x Puller Bridge Stand
• 1 x Rubber Hammer
• 7 x Puller Tab
• 1 x Leveling Pen
• 2 x Glue Stick
• 1 x Plastic Scraper
• 1 x Knob Nut
• 1 x Clean Cloth
• 1 x Release Agent
• 1 x Instruction Manual

Safety Information

1. Wear safety goggles and heavy-duty work gloves during use.
2. Contains glue: keep away from children reach. This product is not a toy. Do not allow children to play with or near it .
3. Use as intended in these instructions only.
4. Check before every use, do not use if parts are loose.
5. Keep product labels and nameplates, they report important safety and technical info on the product.

Instructions for Use

Read the entire important safety info here-above before set up or use of this product!

1. Insert Glue stick into Glue gun . Plug in the Glue gun and let it warm up for 10-15 minutes before use.
2. Using a Clean cloth, clean dent area with the Release agent . Then apply heated glue from Glue gun to the centre of the glue.Select one of the Puller tab according to the dent to be treated, and stick it to the glue. Attention: Keep the Puller tab hold firmly for 10 seconds. Do not push excessively on the Puller tab against the Dent!
3. Place Puller bridge stand over the Puller tab,setting Adjusters to desired length. Screw the Knob nut slowly,and continue to rotate until dent is raised. Stop when dent returns to normal surface level of the car body.
4. Unthread Knob nut and remove Puller bridge stand and Puller tab from treated surface.
5. Use the Release agent in the package to remove the dried glue from the surface. Then, use the Plastic scraper to peel off softened glue patch.
6. If a too high glue spot has been created, use a Rubber hammer and lightly tap the Leveling pen against raised spot to remove.
7. If the dent surface is big then repeat the process. 

Waring

1. Do not use on vehicles previously re-painted or plastered.
2. If the operating ambient temperature is lower than 5℃ (41℉).